• Balboa Vl700s Overlay

Balboa Controller - Balboa Panels - Balboa Displays At Cedar Tubs Direct we off most Balboa Controls for almost every type of Balboa Heater. When choosing Balboa Panel, you should look at matching it with the same type that you currently have.

Most controllers are specific to the model of spa pack you have. A Balboa Display is completely water proof and comes with special sealing two side tape that allows you to quickly replace it.

When Selecting a Balboa Controller, be sure to check the size of your existing hole on your hot tub. If the hole is larger than the new Balboa Panel then you will need to order a special cover plate that fills the hole. It is also wise to purchase a Balboa Display that has an LCD display versus a red LED display. The red LED displays work good at night but can be very hard to read if there is any sunlight on them.

Call us and we can help you find the Balboa Controller that is best for you, 1 800 759 8990!

Replacement Balboa Topside Kit, 7-Button VL700S Serial Standard model with LCD display. OEM part number 53811. This topside panel uses a phone-type connector, 8-wire, with 7ft cord. SpaGuts P/N: 30-200-3811 Button Configuration: 7-Button (Jet1-Jet2-Light-Blower-Temp-Mode) Topside Panel Dimension (Approx): 9.75' L x 3.125' W This topside kit is also a replacement option for the following Balboa topside part numbers: 53896, 53812 (No Overlay; Verify button configuration), 30-175-3811, BAL53811, BB53811, 53896, S53896, HYDSPAVL700S, 3-00-8034, 58-138-1048, 58-138-1648, NSBI53811 NOTE: A standard 53812 topside (Panel Balboa VL700S No O/L) with a 11688 overlay will be provided in a clear sealed bag. This item comes with 1 year limited warranty.

If a longer cord is needed, NOTE: Depending on availability, the Overlay/Label may ship with a different color, text, and/or button shape than the picture shown above. When selecting your spa topside panel, it’s critical that you go by part numbers and not just by appearances or the model number. The part number on a spa topside panel can be found on a white sticker located directly under the topside panel (The ID label may be located on the casing of the topside panel, and the topside panel may need to be removed from the hot tub to get to this label). Buy based on this part number.

Balboa Vl700s Overlay

Model numbers may provide many different options, and choosing the correct option is very critical. Do NOT purchase a hot tub topside panel just because it looks the same as the one you’re replacing. Spa topside panels can look identical, but be programmed differently to work with different spa controllers and circuit boards. ALSO pay attention to the type of cable plug that is on the end of the topside cable.

Different spa topside panels use a certain type of cable plug that plugs into compatible spa controllers and circuit boards. Replacement spa topside panels are shipped in clear sealed bags with Yellow Warning Label.

Verify through the clear sealed bag that the correct topside panel was received prior to opening the bag. Sealed bags that are opened voids the return policy for spa topside panels.